Fileconverter and GSI (Geodäsie/Vermessung)
Hi
first of all thank you for a such good piece of software.
I have new Stonex R2 Total Station and he uses Leica .gsi 16 format. When i convert .gsi to .csv, software shows pt number, coordinates and height but don't show the codes which i have recorded. Can you fix that?
Here is a sample .gsi file with a few codes :
http://www.megafileupload.com/en/file/369124/0123-gsi.html
and this is .csv after converting
http://www.megafileupload.com/en/file/369126/0123-csv.html
( note that all codes are 0 )
any way, thank you once again,
bye!
Ho Pule,
When i convert .gsi to .csv, software shows pt number, coordinates and height but don't show the codes which i have recorded. Can you fix that?
The download package contains an example gsi-file, e.g:
*11+00840000000000001083 81..10+0000004582548303 82..10+0000005937451454 83..10+0000000000012162 71..10+0000000000000005 72..10+00000000000----- 87..10+00000000000----- The point code is encoded at the 71-block - here, the code is 5. Your gsi-file has no 71-block, therefore, no code was extracted.
Here, an source-code output:
else if (str.substring(0,2).equals("71")){ p23.setCode( (removeFirstZeros(str.substring(7,str.length()))).trim()); }
The FileConverter uses a loop over each line in the file. This means, the point information (id, code, x,y,z) must be available in a single line.
kind regards
Micha
--
applied-geodesy.org - OpenSource Least-Squares Adjustment Software for Geodetic Sciences